The DG500 is a popular standalone access control keypad used for door entry systems, garage door openers, and gate control. Known for its durability and backlit metal construction, it allows for PIN code access and often includes a Wiegand interface for integration with larger security systems.
This mode allows a door to stay open until the code is entered again. Latching typically requires using Relay 2 . You must assign a specific user slot to latching by pressing 9 while in programming mode and following the stage-by-stage latching setup instructions .
Upon first connection to the control panel: dg500 keypad manual
Before you start using your DG500 keypad, ensure that it is properly set up and configured. Follow these steps:
You can set the time a door stays unlocked. To change Relay 1, enter programming mode and press 6 . Enter 00 followed by the duration in seconds (01–99). The DG500 is a popular standalone access control
The DG500 keypad is a robust, backlit alphanumeric keypad typically used in security alarm systems and access control panels. This write-up synthesizes standard information found in the official DG500 manual, focusing on setup, user commands, and troubleshooting.
Once your DG500 keypad is set up, you can start using it to control your security system, access control, or home automation. Here are some basic operations: Latching typically requires using Relay 2
The DG500 typically has a terminal block on the rear. Standard wiring is as follows: